Dodge Durango SRT 2018 Owner's Manual page 219

CAUTION!
Do not attempt to raise the vehicle by jacking
on locations other than those indicated in the
Jacking Instructions for this vehicle.
1. Loosen (but do not remove) the wheel lug
nuts by turning them to the left, one turn,
while the wheel is still on the ground.
2. Assemble the jack and jacking tools.
Jack And Tool Assembly
3. For the front tire, place the jack on the body
flange just behind the front tire. Do not raise
the vehicle until you are sure the jack is
fully engaged.
216
Front Jack Location
4. For a rear tire, place the jack in the slot on
the rear tie-down bracket, just forward of the
rear tire. Do not raise the vehicle until you
are sure the jack is fully engaged.
Rear Jacking Location
5. Raise the vehicle by turning the jack screw
clockwise. Raise the vehicle just enough to
remove the flat tire.
WARNING!
Raising the vehicle higher than necessary
can make the vehicle less stable. It could slip
off the jack and hurt someone near it. Raise
the vehicle only enough to remove the tire.
6. Remove the lug nuts and wheel.
7. Install the spare wheel/tire on the vehicle and
install the lug nuts with the cone-shaped end
toward the wheel. Lightly tighten the nuts.
WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the wheel nuts fully until
the vehicle has been lowered. Failure to
follow this warning may result in serious
injury.