Dodge Durango SRT 2018 Owner's Manual page 238

latch release tab and snap it into its locked
position. Latch engagement will be accom-
panied by an audible click.
5. Gently lower the wiper blade onto the glass.
Rear Wiper Blade Removal/Installation
1. Lift the rear wiper arm pivot cap away from
the glass to allow the rear wiper blade to be
raised off of the glass.
NOTE:
The rear wiper arm cannot be fully raised off the
glass unless the wiper arm pivot cap is un-
snapped first. Attempting to fully raise the rear
wiper arm without unsnapping the wiper arm
pivot cap may damage the vehicle.
Wiper Pivot Cap In Unlocked Position
1 — Wiper Arm Pivot Cap
2 — Wiper Arm
2. Lift the rear wiper arm fully off the glass.
Wiper Blade In Folded Out Position
1 — Wiper Arm Pivot Cap
2 — Wiper Arm
3 — Wiper Blade
3. To remove the wiper blade from the wiper
arm, grasp the bottom end of the wiper blade
nearest to wiper arm with your right hand.
With your left hand hold the wiper arm as you
pull the wiper blade away from the wiper arm
past its stop far enough to unsnap the wiper
blade pivot pin from the receptacle on the
end of the wiper arm.
NOTE:
Resistance will be accompanied by an audible
snap.
4. Still grasping the bottom end of the wiper
blade, move the wiper blade upward and
away from the wiper arm to disengage.
Wiper Blade Removed From Wiper Arm
1 — Wiper Blade
2 — Wiper Blade Pivot Pin
3 — Wiper Arm
4 — Wiper Arm Receptacle
5. Gently lower the tip of the wiper arm onto the
glass.
Installing The Rear Wiper
1. Lift the rear wiper arm pivot cap away from
the glass to allow the rear wiper blade to be
raised off of the glass.
NOTE:
The rear wiper arm cannot be fully raised off the
glass unless the wiper arm pivot cap is un-
snapped first. Attempting to fully raise the rear
wiper arm without unsnapping the wiper arm
pivot cap may damage the vehicle.
235