Table of Contents
Advertisement
Accessories
There are several components of the M2 RO that can be configured from the Accessories manu, including:
• Wireless Remote
• Modem
• Flow Meter
• Pressure and Level Control Switches
• Pressure Gauges
• Total Dissoved Solids Probes
• Error or Status Monitor
• SV3 or Target TDS Monitor
Wireless Remote
1.
Select a location for the wireless remote monitor (Figure 11). The location must be near an electrical outlet. If a
modem is used in the remote, then the location should also be near a standard RJ-11 type telephone wall jack.
CAUTION!
Do not touch any surfaces of the circuit board. Electrical static discharges may cause
damage to the board. Handle the circuit board by holding only the edges of the circuit
board. Keep replacement boards in their special anti-static bags until ready for use.
Mishandling of the circuit board will void the warranty.
2.
Use the Hole Drilling Template as a guide to drilling two holes to mount the remote monitor. If drilling into wall
board, drill two 5/16" diameter holes and insert the plastic drywall anchors into the holes securing them with the
two #10 screws provided. If drilling into a solid surface, drill two 7/32" holes into the surface and screw the two
#10 screws into the holes. In either case, leave a gap of approximately 3/32" between the head of the screw
and the wall.
3.
(Optional) If a modem is to be installed into the remote monitor, refer to
4.
Connect the power cord to the bottom of the remote monitor. If a modem is to be used in the remote, plug a
standard telephone extension cord into the bottom of the remote monitor.
5.
Hang the remote monitor on the two screws. Plug into a 120V outlet.
6.
Disconnect power to the RO unit. Open the control.
Culligan® Series M2 Reverse Osmosis
28
5 3/8"
SCREWS
Figure 11.
POWER CONNECTION
Wireless remote monitor.
page 36
28
MODEM CONNECTION
for installation and setup.
Cat. No. 01023095
Hide quick links:
Advertisement
Table of Contents
