Setup - Culligan M2 Series Installation, Operation And Service Instructions

After completing the first time setup for the RO, you must also complete the system setup for flush modes, accessories,
and error limits before completing the initial startup.
Flow Meter K-Factor setting is required during setup. All other RO settings are optional depending on the accessories
installed. The RO controller does not require any specific setup to run unless accessories are installed or will be installed.
RO accessories include:
Accessory
Flush Valves
Flow Meters
Wireless Remote, RF Board
Level Controls
Repressurization System
Pretreatment Lockout
Pressure Transducers (G2, G3 only)
System Setup
Set Up Time/Date
If the unit loses time for some reason, you can use this setting to reset the correct date and time. Please note that if you
have a modem installed and connected to the phone line, the unit will check for the correct time each time it calls in.
RUNNING
JAN-01-12 12:01P
1) GO TO RUNNING
2) GO TO OFFLINE
3) INFORMATION
>4) SETUP
>1) TIME/DATE
2) LANGUAGE
3) POWERON MODE
4) FLUSH MODES
Time/Date Settings
Screen Display
SET
JAN
MONTH
SET
1
DAY
Cat. No. 01023095
Modem
1. From the default home screen, press
2. Press to scroll to 4) SETUP.
3. Press to select the SETUP menu.
4. Set Time/Date is the first menu item, so press
The screen displays the first setting that can be changed.
Range
1.
Jan–Dec
2.
1–31
Global RO Controller (GROC) Setting
Setup—>Flush Modes
Setup—>Accessories—>Flow Meters
Setup—>Accessories—>Modem
Setup—>Accessories—>Wireless Rem—>Channel #
Setup—>Accessories—>Switch Inputs
Setup—>Accessories—>Switch Inputs
Setup—>Accessories—>Switch Inputs
Setup—>Accessories—>Press Gauges
. The screen displays the main menu.
Procedure
The screen displays the month setting. Press
and then to change the value and see the next setting.
The screen displays the day setting. Press
then to change the value and see the next setting.

Setup

to select 1) SET TIME/DATE.
or
or
Setup
and
21