Error Code List - NEC DLP Cinema NC3541L Installation Manual

Appendix

5-2. Error Code List

Please inquire your dealer/distributor about action to be taken for each error code.
Error
Code
5 Light Unlit
12 EEPROM R Fail
13 Interlock Fail
15 EEPROM W Fail
120 DLP Ack Fail
121 Lens Fail
135 FMT FPGA Boot Fail
136 FMT FPGA System Fail
137 LoginMgr Comm Fail
138 LoginMgr Boot Fail
141 DLP CommE Fail
143 FMT Board Config Mismatch
165 GPI MACRO(n) Selection Invalid
166 GPI Control Invalid
177 Tamper Fail
178 Marriage Tamper Fail
190 The Validity has expired.
191 Different Serial Number
192 Model Code Mismatch
230 Router Fail
271 IMB:SD Tamper Terminate
301 System Error
302 Self Test Error
303 Install Release Package Error
304 Load Release Package Error
305 Key Error
306 Certificate Error
329 Sequence Data File Mismatch
331 Flash Checksum Error - Sequence Data
333 Satellite Hardware Mismatch
334 FSB Flash Update Error
335 Red Satellite Reports Reset
336 Red Satellite Serial Link Error
337 Red Satellite Firmware Configuration Error
342 Green Satellite Reports Reset
343 Green Satellite Serial Link Error
120
Error message
The light source is not on.
E2PROM data read error is detected.
Interlock is activated.
E2PROM data write error is detected.
ICP failed operation. It could be caused by configuration files lost, disk
space issue, or DISKCHIP corruption issue.
Lens unit control error.
FMT FPGA failed to boot.
FMT FPGA failed to system startup.
Login Manager communication error.
Login Manager failed to boot.
No communication with the ICP board and DCC.(Communication I/F is
Ethernet)
DPSW setting of FMT board is inappropriate.
Selection of preset button (n) through GPI is invalid because metadata is
enabled.
* This message would be shown on Log, not on LCD.
Projector control through GPI is invalid because projector is busy.
* This message would be shown on Log, not on LCD.
Service door tamper switch of projector is open.
Marriage tamper switch of projector is open.
The time limit for use of the projector has expired.
* In cases when the validity setting has been configured with the projector.
There is a mismtach in the serial number of the main unit internally saved
on the projector.
There is a mismtach in the model code of the main unit internally saved on
the projector.
Failed to control router.
Terminated service door tamper event latched by IMB.
* This message would be shown on Log, not on LCD.
ICP system status error.
ICP system status error.
To recover the issue, update ICP to higher than Prod3.0 or equal. If that
can not remove the issue, remove and reseat the ICP board.
ICP system status error.
It could be caused by disk space issue or DISKCHIP corruption issue.
ICP system status error.
It could be caused by disk space issue or DISKCHIP corruption issue.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
ICP system status error.
Description