Table of Contents
Advertisement
Projector Adjustment and Connecting
3-6-2. Adjusting the Screen Angle
Preparation:
Display the zoom/focus adjustment screen by using the following procedure.
[1] Press the MENU button on the projector's control panel.
"Title Select" appears on the projector's LC display.
[2] Select "Configuration" menu using LEFT the LEFT/RIGHT button.
[3] Press the DOWN button.
[4] Select "Lens Control" using the LEFT/RIGHT button.
[5] Press the DOWN button.
[6] Press the ENTER button.
"Focus Zoom" is displayed and you can adjust the focus/zoom.
1
Press the LEFT/RIGHT buttons to roughly
adjust the screen size so that the screen
height and the image height are the same.
2
Press the UP/DOWN buttons to roughly
adjust the focus.
3
Adjust the surface on which the projector is
set up and the level adjuster of the projector
to adjust the setup position, height, and tile
(front-back and left right) of the projector so
that the projected image is level at the screen
center.
4
Use the LEFT/RIGHT buttons again to adjust
the screen size so that the projected image is
kept 0.5 to 1 crosshatch cell portions higher
than the top edge of the screen.
5
Finally adjust the focus using the UP/DOWN
buttons.
6
Press the EXIT button several times.
The projector exits the menu and goes back to the regu-
lar screen.
94
Advertisement
Table of Contents
