Al Edit Recording - Aiwa CX-NMT90 Operating Instructions Manual

Al EDIT RECORDING
o-9
The Al edit function enables CD recording without worrying about
tape length and track length. When a CD is inserted, the unit
automatically calculates the total track length. If necessary, the
order of tracks is rearranged so that no track is cut short,
(Al: Artificial Intelligence)
Al edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side,
1
2
3
4
5
Insert the tape into deck 2, and press the DOLBY
NR button to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit,
Press the CD button and load the disc(s).
Press the CD EDIT/CHECK button ~.
"EDIT" and "Al" lights up on the display.
When "PRGM" is displayed, press the CD EDIT/CHECK button
again,
Press one of the DISC DIRECT PLAY buttons to
select a disc.
Press the 4 or ~ button to designate the tape
length.
10 to 99 minutes can be specified.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
The numbered buttons on the remote control are also
available to designate the tape length.
Example: When using a 60-minute tape, press the 6 and O
buttons.
Tape length
Tape side A Selected
(front side)
tracks for side A
6 Press the REC/REC MUTE button to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press the button, Recording and CD play stop simultaneously.
To clear the edit program
Press the CLEAR button twice so that "EDIT" disappears on
the display.
To check the order of the programmed track numbers
Before recording, press the CD EDIT/CHECK button to select
side A or B, and press the - or - button repeatedly.
Programmed
Track number track numbers
Program number
To
add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment
1
2
3
4
Press the CD EDIT/CHECK button to select side A or B,
Press one of the DISC DIRECT PLAY buttons to select a
disc.
Press the numbered buttons on the remote control to select
tracks. PRGM appears on the display.
A track whose playing time is longer than the remaining time
cannot be programmed.
Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
m
Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
The Al edit function cannot be used with discs containing 31
tracks or more.
Remaining
time of side A
15
ENGLISH