Al Edit Recording - Aiwa XR-M7 Operating Instructions Manual

Al EDIT RECORDING
'The A! edit function enables CD recording without worrying about
tape length and track length. When a CD is inserted, the unit
automatically calculates track lengths. If necessary, the order of
tracks is rearranged so that no track is cut short.
(Al: Artificial intelligence)
Al edit recording does not start from @ point halfway in the tape,
The tape must be recorded from the beginning of either side.
Use the remote controt from steps 3 to 6.
1 Insert the tape into the deck.
Insert the tape with the side to be recorded first facing out.
2 Press the CD buiton and load the dise(s).
3 Press the EDIT/CHECK button once.
"EDIT lights up and "Al" flashes on the display.
Each time it is pressed, the display changes as follows:
[re EDIT——» PRGM EDIT —
4 Press one of the DISC DIRECT PLAY buttons to
select a disc.
5 Press the numeric buttons on the remote control
to designate the tape length.
10 to 99 minutes can be specified,
Example: When using a 60-minute tape, press the 6 and 0
buttons.
In a few seconds, the microcomputer determines the tracks
to be recorded on each side of the tape.
The <€< and > buttons are also available to designate the
tape length.
DISPLAY
@ Tape length
@ Tape side A (front side)
@ Remaining time of side A
@ Selected tracks for side A
6 Press the @/O REC/REC MUTE button and then
press the <> button within 2 seconds to start
recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and then
recording starts. After recording on the front side (A) ends,
recording on the back side {B) starts.
oe
nS
ze tare
PERT BE
To stop recording
Press the Ml button. Recording and CD play stop simultaneously.
6 REC/REC MUTE DIRECTION To clear the edit program
(5)
Press the I CLEAR button twice so that EDIT disappears on
= the display.