Setting The Sleep Timer; Power Is Turned Off - Aiwa CX-NA50 Operating Instructions Manual

To check the specified time and source
Press the TIMER button while pressing the SHIFT button. The timer-on time, the selected source name and the
duration for the timer-activated period are displayed for 4 seconds.
To cancel timer standby mode temporarily
¥ ¥
Press the TIMER button repeatedly while pressing the SHIFT button repeatedly so that or REC disappears on
the display.
¥ ¥
To restore the timer standby mode, press again to display or REC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before the turning off the power, repeat step 5 to prepare the source, and adjust the volume and tone.
NOTE
• Timer playback and timer recording will not begin unless the power is turned off.
• Connected equipment cannot be turned on and off by the built-in timer of this unit. Use an external timer.
TIMER RECORDING
Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.
¥
Press the TIMER button twice while pressing the SHIFT button so that REC appears on the display, and
press the SET button within 4 seconds. Repeat the steps shown above from step 2 and insert the tape to be
recorded into deck 2 after step 5.

SETTING THE SLEEP TIMER

The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press the SLEEP button while pressing the SHIFT button.
2 Within 4 seconds, press the or button to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.