Programmed Edit Recording - Aiwa CX-NA50 Operating Instructions Manual

6 Press the REC/REC MUTE button to start recording.
The tape is rewound to the beginning of the front side, the lead segment is played through for 10 seconds, and
recording starts. When recording on the front (side A) ends, recording on the back (side B) starts.
To stop the recording
Press the button. Recording and CD play stop simultaneously.
To clear the edit program
Press the CLEAR button twice so that "EDIT" disappears on the display.
To check the order of the programmed track numbers
Before recording, press the EDIT/CHECK to select side A or B, and press the
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment.
1 Press the CD EDIT/CHECK button to select side A or B.
2 Press one of the DISC DIRECT PLAY buttons to select a disc.
3 Press the numbered buttons on the remote control to select tracks. "PRGM" appears on the display.
A track which has a playing time longer than the remaining time cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than the specified recording time printed on the label.
This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape's
specified recording time after editing, the display shows the extra time without a minus mark), instead of the time
remaining on the tape (with the minus mark).
NOTE
• Recording is inhibited if the erasure prevention tab on either side of the tape is broken off.
• The edit function cannot be used with discs containing 31 tracks or more.
RECORDING (cont.)

PROGRAMMED EDIT RECORDING

or button repeatedly.
pg. 16