Setting The Timer - Aiwa CX-NA50 Operating Instructions Manual

1 Press the CLOCK button while pressing the SHIFT button on the remote control, and press the
button within 4 seconds.
2 Press the DOWN or
The hour stops flashing and the minute starts flashing.
3 Press the DOWN or
The minute stops flashing on the display and the clock starts from 00 seconds.
To display the current time
Press the CLOCK button while pressing the SHIFT button on the remote control. The time is displayed for 4
seconds.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press the CLOCK button while pressing the SHIFT button on the remote control and then press the
4 seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be
reset.

SETTING THE TIMER

UP button to designate the hour, and press the
UP button to designate the minute, and press the
SET
SET button.
SET button.
button within