Electro-Harmonix Attack Decay Manual page 4

USING CONTINUOUS ENVELOPES (TREMOLO)
1. Ensure the POLY button is off.
2. Set the ATTACK and DECAY knobs to 9 o'clock.
3. Set SENS to 50% or where you normally like to set it.
4. Press on the BYPASS footswitch and hold it down.
5. Now press on the HARMONIX footswitch and release it. You don't need
to hold HARMONIX.
6. Release BYPASS.
7. Play some notes, you should hear the Attack envelope restart
automatically once the Decay envelope finishes its run.
8. Continuous Envelope can also be enabled for POLY mode. Repeat the
same procedure but change Step 1 so that the POLY button is lit.
CREATING A CUSTOM EXPRESSION SWEEP
1. In this example we will create a custom expression sweep for the
DECAY knob. You can follow the same procedure to make an
expression sweep for any of the knobs.
2. Make sure a compatible expression pedal is connected to the EXP jack.
3. Press and hold BYPASS then press and release the PRESET 1 button.
4. Both the PRESET 1 LED and Status LED, near BYPASS, will blink at a
steady pace.
5. Turn the DECAY knob to its 50% setting. This will be assigned to the
expression's heel position.
6. Press and release the PRESET 1 button. Both LEDs will blink faster.
7. Turn the DECAY knob to its minimum setting. This will be assigned to
the expression's toe position.
8. Press and release the PRESET 1 button. Both LEDs will blink even
faster for one second and then stop blinking.
9. Play some licks and rock the expression pedal. The decay time should
get shorter as the pedal is moved from heel to toe.
10. Try this same procedure with other knobs or multiple knobs at once.
SAVING A PRESET
1. Create a setting on the Attack Decay that you really like.
2. Choose one of the preset slots to save the setting. For our purposes
let's choose PRESET 2.
3. Press and hold the PRESET 2 button. After one second all the Preset
buttons blink. After two seconds they cease blinking.
4. Release the PRESET 2 button after LEDs stop blinking.
5. The preset is saved.
6. To recall a preset, press and release the corresponding Preset button.
The button will light solid indicating that a preset is loaded.
4