Page 2
Da-Lite® is a registered trademark of Milestone AV Technologies. connection with the installation or use of this subject to change All rights reserved.
Page 3
Frame Assembly 3. Slide the frame sections together at the corners. 1. Unwrap the frame pieces. Before assembling the frame pieces, add 2 nuts (A) to either end of the top frame section 4. Secure the frame pieces by tightening the hex nut screws and the top of the side frame for the mounting bracket and which are already inserted in the frame.
Page 4
Decide on the preferred installation method. You can position 5. Secure the mounting bracket (C) with provided screws to the the mounting bracket of the FullVision on the top frame, side previously inserted nuts. frame, or above the top frame to fly the screen.
Page 5
Installation (continued) 7. Assemble the frame installation tool (J) 8.2 Screens 160" and wider require a spreader bar. Connect the top and bottom frame with the spreader bar and connect this by using the two supplied screws (D). 8. Position the frame on the frame installation tool and lean against the wall.
Page 6
11. When the fabric is attached on top, attach the fabric on the sides. Then rotate the frame and attach the remaining surface at the top. 13. Hang the FullVision brackets over the screws to position it on the wall.
Page 8
Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the purchaser and Da-Lite is not responsible for damage in shipment.
Need help?
Do you have a question about the FullVision and is the answer not in the manual?
Questions and answers