Environmental Protection; Plug Replacement - Worx WG200E Instruction Manual

between the two blades (See K).
Your trimmer should be stopped, disconnected
and oiled occasionally during use.
AT THE END OF THE CUTTING SEASON
Clean your Hedge trimmer thoroughly.
Check that all nuts and bolts are secure.
Visually inspect the Hedge trimmer for any
worn or damaged parts.
TO STORE YOUR HEDGE TRIMMER
The Hedge trimmer blade cover/storage holder
is provided with 2 hanging slots for storing
the Hedge trimmer on the wall (See L) Ensure
the blade cover/storage holder is fitted before
storage. Store in a dry place where your Hedge
trimmer can be protected from damage.
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
Hedge Trimmer

PLUG REPLACEMENT

(UK & IRELAND ONLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows. The wire
which is coloured blue must be connected to
the terminal which is marked with N. The wire
which is coloured brown must be connected to
the terminal which is marked with L.
WARNING: Never connect live or
neutral wires to the earth terminal of the
plug. Only fit an approved BS1363/A plug and
the correct rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
Cable grip
firmly clamped
13
13 Amp fuse approved
to BS1362
Brown L (live)
EN