Starting And Stopping - Worx WG200E Instruction Manual

SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Warning
Wear eye protection
Wear ear protection
Wear dust mask
To avoid possibility of electric
shock, do not expose to rain
Remove plug from the mains
immediately if cable is damaged
or cut
Double insulation
Keep hands away
WEEE marking
Hedge Trimmer
WARNING! DO NOT USE
THE PRODUCT WITHOUT
FITTING THE GUARD AND
FRONT HANDLE.
ASSEMBLY OF THE GUARD
Insert the guard into the slot as illustrated in
Fig A, allow the two locking tabs to insert into
the holes, ensure it is securely located.
Then use two screws to fix the guard securely.
THE FRONT HANDLE, MUST BE
ASSEMBLED BEFORE USE:
1) First, insert the left grooves-side to the
housing. (See B)
2) Pull to insert the other side of the front
handle to the other side of the housing.
(See B)
3) Rotate each lock nut (7) as shown in Fig C.
Check and ensure the lock nuts are locked onto
the main housing.

STARTING AND STOPPING

BEFORE STARTING YOUR HEDGE
TRIMMER
Remove blade cover (10) as illustrated in D.
TO START YOUR HEDGE TRIMMER
There are two switch levers fitted in your
Hedge trimmer (2&4).
Both switch levers need to be depressed for
the product to start. Depress and hold the front
switch lever (4) and press the switch lever (2)
(See E).
TO STOP YOUR HEDGE TRIMMER
Move Hedge trimmer away from cutting area
before stopping.
To stop, release one of the switch levers
(See G).
WARNING: If any parts are missing,
damaged or broken, do not operate
your Hedge trimmer until all damaged
parts have been replaced or repaired.
Failure to do so could result in serious
personal injury.
11
EN