Programming Filter Cycles (J-Lx/ 2011-2013 J300 Collection) - Jacuzzi LED Series Manual

E. F0-F3 Standard Skimming/Heating Modes (J200 Cellection; F0 Mode used on 2011-2012 circulation
pump models)
Standard filtration/heating modes are typically selected by customers that use their spa on a frequent basis
and desire a fully heated spa when lifting the cover. In these modes, the water temperature is regulated
by the set temperature, and heater which turns on as needed. After the programmed set temperature is
reached, the heater turns off followed by the jets pump 1 unless a programmed filtration cycle is running.
Note: Standard modes may consume more energy than Economy models below in cold or freezing climates.
F. F4-F6 Economy Skimming/Heating Modes (J200 Cellection)
Economy filtration/heating modes are typically selected by customers in warm climates where heat up
times are minimized due to higher ambient temperatures. In these modes, the water temperature is regu-
lated by the set temperature, and heater only while a programmed filter cycle is running (unless in summer
logic; refer to Section 5.4, page 14).
Note: Economy modes may consume less energy than standard modes above in cold or freezing conditions.
G. Lock Modes L1-L3
These modes are designed for use during spa service or to prevent unauthorized use.
Note: Economy modes may consume less energy than standard modes above in cold or freezing conditions.

4.3 Programming Filter Cycles (J-LX/ 2011-2013 J300 Collection)

To select a pre-programmed filter cycle or lock mode, press and hold both control panel WARMER
and COOLER buttons at the same time, then release. Then press either WARMER or COOLER
buttons to select either filter mode F0-L2. During the filtration heating cycle the jets pump1 low speed
and circulation pump will activate.
Standard Mode
F0 5 minutes of filtration per day (one 5 minute "Blow-Out" cycle every 24 hours to purge all plumbing lines.
F1 1 hour of filtration per day (one 30-minute cycle every 12 hours); this is the factory default setting.
F2 1.5 hours of filtration per day (one 30-minute cycle every 8 hours).
F3 2 hours of filtration per day (one 30-minute cycle every 6 hours).
Economy Mode
F4 1 hour of filtration/heating per day (one 30-minute cycle every 12 hours).
F5 1.5 hours of filtration/heating per day (one 30-minute cycle every 8 hours).
F6 2 hours of filtration/heating per day (one 30-minute cycle every 6 hours).
Lock Mode
L1 Lock Out (disables all hot tub functions to permit filter cleaning).
Note: The spa should not be left in this lock mode for an extended period of time. Especially in colder climates
or when freezing conditions exist.
L2 Lock Mode (disables the jets buttons to prevent unauthorized use of the hot tub) filtration/heating
cycles and heater will continue to operation as programmed in this mode. The temperature display
flashes when this function is enabled. Example: The "F3" filter cycle was enabled prior to choosing lock
mode. The hot tub continues to perform filter cycle "F3" until lock mode is canceled, allowing another
filter cycle to be selected.
L3* Lock Mode (disables the temperature up and down buttons to prevent unauthorized temperature
adjustments). Filtration/heating cycle will continue to operate as programmed in this mode. The jets and
lights buttons will still continue to operate as normal. The temperature display flashes when this function
is enabled. *Due to a difference in software this feature is not available for all models, started in 2014.
Note: To exit a Lock Mode you will need to re-enter the filtration/heating modes and select a cycle from F0-F6.
8