2012+ Clearray Not Working - Jacuzzi LED Series Manual

8.9 2012+
CLEARRAY
Verify that the CLEARRAY system should be running before proceeding (no error message, not in summer logic.
CLEARRAY turns off when either jets button is pressed and will remain off for 5 minutes after function ends.
Diagnostic Tools: Clamp-on Ammeter, Voltmeter
Suggested Spare Parts: CLEARRAY ballast, UV bulb, circuit board, control panel
Standard Troubleshooting Approach.
This applies to 2011-2013 J300 Models not 2014+
Turn power to hot tub off and on.
Wait approximately two minutes for
filter cycle to begin and turn on the
circulation pump and CLEARRAY (J-LX,
J300 and J200 with circ pump Models)
or Pump 1 and CLEARRAY (J200
Models).
DO NOT press either JETS button at
this time or the CLEARRAY will shut off!
Is filter cycle 1 running?
Yes
Is 120 VAC* or 240 VAC present at
circuit board CLEARRAY outputs?
Test points 16 and 17, See pages
50-53.
*Convertible J-210, J-315, J-325 models
only.
Yes
Is there current draw (0.4 Amp) on the
CLEARRAY? Check with clamp-on
ampmeter.
Yes
Current draw is proof that CLEARRAY
is working. Read steps outlined above
to ensure customer understands the
logic.
Ballast
Not Working
Refer to pages 50-53 for testing points.
No
No
No
UV bulb
Turn power off, plug in spare
control panel, then turn power
on. Wait approximately 2
minutes for filter cycle to begin.
Is filter cycle running?
Yes
Replace control panel.
Replace circuit board.
Is the green light lit on the
ballast?
Yes
Is the red light lit on the
ballast?
Yes
Turn power off, plug in spare
panel, then turn power on. Is
CLEARRAY indicator lit?
Yes
Replace control panel.
DANGER: Electrical Shock Hazard Exists!
High Voltage Present on Circuit Board. Use
Extreme Caution while Servicing Circuit Board.
No
Replace circuit board.
No
Replace ballast.
No
Replace UV bulb.
No
Replace circuit
board.
37