11.0 Programming Instructions
11.1 Programming Filter/Circulation Pump Run Time
The Sentry control system allows you to easily adjust two separate
aspects of filter/circulation pump operation:
1. The time of day (start time) the filter/circulation pump turns on.
2. The length of time (duration) the filter/circulation pump operates.
The factory default start time is 12:00AM (Midnight). The default duration
is 24-hours. To make adjustments, press the CYCLE
times to enter the filter/circulation pump programming mode. The LCD
screen display "Circ". At this time the system is ready to accept your
changes:
•
Press the SELECT
start time appears on the LCD display.
•
Press WARMER
start time in 30-minute increments.
•
Press the SELECT
•
Press WARMER
the duration time in 1 hour increments.
•
Press DISPLAY
water temperature display. Note: If no button is pressed within 30
seconds, all changes are recorded and the screen automatically
returns to the standard water temperature display.
Note: when the standard mode is selected (sec. 10.3, page 36), the filter/
circulation pump automatically turns on for a heat call regardless of the
pump's programmed start time and duration.
11.2 Programming Filter Cycles
Your spa comes with four 30-minute filter cycles which activate the filter/
circulation pump. These cycles are factory programmed to start at 6:00
am, 12:00 (noon), 6:00 p.m., and 12:00 (Midnight). The control system
allows you to easily adjust two separate aspects of each cycle: 1) the
time of day at which it begins; 2) the duration of the cycle.
Note: When "Standard" mode is selected (sec. 10.3, page 36) and the
filter/circulation pump is set to the factory default duration of 24-hours
(sec. 11.1), each cycle is displayed on the main control panel, when
button once. The previously programmed
or COOLER
buttons to program duration.
or COOLER
button to save changes and recall the main
button five
buttons to adjust the
buttons to program
Page 37