Husqvarna PG 510 Operator's Manual page 8

Servicing position
CAUTION: Only put the product in the
servicing position on a horizontal surface.
Tilted transport position
Lift transport position
Put a protection between the motor and the electrical
enclosure to prevent damage to the product.
To adjust the handlebar
The handle lock knobs are operated clockwise,
counterclockwise or put in idle position.
8
1. Loosen the lock knobs (A) and adjust the handle (B)
to idle position.
A
B
2. Tighten the lock knobs to set the position.
3. When the handle position is set, pull the handle lock
knobs up (A) and put them into idle position (B).
A
B
To adjust the frame height
The angle of the frame can be changed to divide the
weight of the chassis. This is to decrease or increase
the grinding pressure against the surface.
Adjust the angle to set up a good work position for
different operators.
A
A
B
1146 - 001 - 29.04.2019