Operation - Husqvarna PG 510 Operator's Manual

3. Turn the ON/OFF switch to 1 to start the product.
4. Wait for 5 seconds, this is to let the product operate
at the idle speed.
5. Turn the ON/OFF switch to 0 to stop the product.
Emergency stop
The emergency stop is used to quickly stop the motor.
The emergency stop at the product breaks the mains
power supply.
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
1146 - 001 - 29.04.2019
To do a check of the emergency stop
1. Push the emergency stop button (A) and make sure
that the motor stops.
A
2. Turn the emergency stop button clockwise (B) to
disengage.
Safety instructions for maintenance
• Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Stop the product when you replace the diamond
tools. Turn the ON/OFF switch to 0 and push the
emergency stop button.
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Do the maintenance to make sure that the product
operates correctly. Refer to
page 13

Operation

Product positions
Operation position
B
Daily maintenance on
7