SHENZHEN ENCOM ELECTRIC TECHNOLOGIES CO. EN500 Series Service Manual page 100

Table of Contents

Advertisement

return to C-00 parameter monitor. For example: pressing
from C-00 to C-01, continuous pressing the same button: parameter switch from
C-01 to C-02: then pressing
contents various as different monitor parameter: refer to parameter F00.01.
Monitor parameter group C-00~C-05 have run and stop modes.
For example C-00 display different physical value under run and
Note
stop two modes.
Power-on fault monitor
F00.13
parameter selection
When the parameter power on first time: C monitor parameter group display
under drive run or stop status, For example F00.13=1, power on or stop to monitor,
display parameter setup by C-01;when F00.02=3, F00.08=6, power on, inverter
stops, busbar voltage display; inverter runs, output frequency and keypad display.
Pressing
monitor C-00 for the setting motor value.
Parameter operation
F00.14
control
Units digit: To define which parameters will be allowed to modify.
0: All parameters are allowed to modification.
1: Excerpt this parameter, the other parameter is not allowed to
modification.
2: Except F01.01, F01.04 and this parameter, the others parameter are
not allowed to modification.
Tens digit: To define which parameters will be resumed factory default value
0: No action.
1: All parameters return to default.(not include fault record parameter
group(F26 group) parameter).
2: Except for motor parameter: all parameters return to default. (not
include F15 and F26 group parameter).
3: Extension parameter return to default.(only F21~F24 group parameter
return to default).
4: Virtual parameter return to default.(only F20 group parameter return to
default).
5: Fault record return to default. (Only fault record parameter group (F26
group) restores factory default).
Hundreds digit: Locked key that definite the keypad when locking function is
valid.
0: All locked.
7 Detailed function specification
return to C-00 parameter monitor. Monitor
Range: 0~5
Range: units digit: 0~2
tens digit: 0~5
hundreds digit: 0~4
parameter switch
0
000
93

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EN500 Series and is the answer not in the manual?

Table of Contents