Table of Contents
Advertisement
OD-514B, OD-515B & OD-545B INSTRUCTION MANUAL
Rear Panel
[45]
Z AXIS INPUT. Input terminal for external CRT intensity modulation signal. Trace
brightness is reduced when a positive signal is applied and it is increased when a
negative signal is applied.
[46]
CH1 OUTPUT input. Delivers the CH 1 signal with a voltage of approximately
100 mV per 1 DIV of graticule. When terminated with 50
attenuated to about one half. Suitable for frequency counting, etc.
[47]
Power input connector. It allows to connect or disconnect the mains cord.
[48]
Fuse and line voltage selector. It allows to change the operating voltage range.
[49]
Studs for laying the oscilloscope on its back to operate it in the upward posture.
Also used to take up the power cord.
November 2000
Figure 5.- Rear panel.
:
, the signal is
Page 17
Advertisement
Table of Contents
