Pentair Autotrol 255 Installer Manual page 44

Installer Manual 255/LOGIX 742-762-764 - Programming
11. "g/L"
12. "KG"
13. "x100"
3
14. "Lbs/ft "
15. Faucet
16. Maintenance interval
17. Digits
18. Number
19. History values (H)
20. Parameter (P)
21. Cycle (C)
22. Hardness
23. Capacity
24. "x2"
25. Regeneration sign
26. Salt
27. Regeneration time
28. Time and day
44 / 92
Indicates that the value entered/displayed for salt amount is in grams/
Liter of resin.
Indicates that the value entered/displayed is in kilograms or kilograins.
x100 multiplier for large values.
Indicates that the value entered/displayed for salt amount is in pounds
per cubic foot.
Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
Displayed when the months in service exceed the value programmed in
parameter P11.
Four digits used to display the time, flow rate, volume capacity,
program value or error codes.
Used with #19, #20 and #21.
Displays a sequence numbers or values.
The number displayed by #18 identifies which history value is currently
displayed.
Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
The number displayed by #18 is the current cycle in the regeneration
sequence.
Hardness setting - only used with 760, 762 and 764 controllers for 8-
cycles softening system.
Shows estimated system capacity.
Indicates a second regeneration has been called for.
Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
Salt amount for each regeneration setting.
If the controller is on a 3-cycles filter then the backwash time is
displayed.
Time of regeneration and days of regeneration setting.
Days of regeneration setting is only available on 742 controller.
Current time and day setting.
Ref. MKT-IM-021 / A - 20.02.2019