Thermo Scientific Orion 7070iX Quick Start Manual

QUICK START GUIDE
Thermo Scientific Orion 7070iX
Total Residual Oxidant Analyzer
Figure 1 - Orion 7070iX TRO Analyzer
Unpacking the Orion 7070iX TRO Analyzer
Thermo Scientific Orion
™ ™
(TRO) Analyzer is assembled, tested and packaged with
great care.
1. Open the box and remove the accessories boxes from
the top, See "Figure 2 - Unpacking the 7070iX TRO
Analyzer".
CAUTION: The equipment exceeding 40 lbs.
should be lifted with the help of two persons
or follow any heavy lifting policies your
employer has put in place.
2. The shipping box contains the analyzer, LVD safety
manual, quick start guide and user manual usb drive.
3. Place the analyzer at a suitable location until installation
is completed.
Figure 2 - Unpacking the 7070iX TRO Analyzer
7070iX Total Residual Oxidant
Mounting the 7070iX TRO Analyzer
The Orion 7070iX TRO Analyzer should be installed in a
well ventilated location with ambient temperature between
5 °C and 45 °C (41 ° to 113 °F); and relative humidity must
not exceed 85% at 40 °C (104 °F). The area must be free
from dust, corrosive gases, vibration and shocks; sheltered
from direct sunlight, and shielded from dripping water.
1. Use four #10 screws or equivalent for proper support.
2. Refer to "Figure 3 - Dimension drawing of 7070iX
TRO Analyzer for mounting" for dimensions (in mm
and inches).
3. Make sure that the wall you choose can support the
weight of the instrument. (Approximately 20 kg or 44
lbs.)
4. Locate the instrument as close to the sampling point as
possible to ensure complete purging of the sample line
during each cycle.
5. Allow approximately 610 mm (24") of clearance on the
left side for door swing. Also, allow enough clearance on
the right side for wiring conduit.
6. Locate the Analyzer height such that the display is at
eye level for an operator, also allowing for appropriate
sample and drain connections.
7. Locate the dedicated external power switch or follow
local regulations for power supply.
Orion 7070iX TRO Analyzer