Communication With Media 6 Differential Pressure And Flow Meter - Samson Media 6 Original Instructions Manual

Communication with Media 6 Differential Pressure and Flow Meter
To download configuration data from the software to the SAMSON memory pen or to up-
load data from the memory pen, a SAMSON modular adapter must be inserted into the seri-
al interface of the PC or laptop to connect the memory pen. See the Operating Instructions
u EB 6661 for TROVIS-VIEW 4 software.
When the Media 6 device is not connected, the default settings are shown in
TROVIS-VIEW 4. A TROVIS-VIEW 4 file (*.tro) can be loaded and edited by selecting Open
in the File menu.
Note:

New records created in TROVIS-VIEW 4 firmware version 3.00 or higher are not
compatible with earlier versions (e.g. firmware version 2.30).
2 Communication with Media 6 Differential Pressure and Flow
Meter
To establish communication between the software and the Media 6 device, the electrical con-
nection of the Media 6 device must be performed as described in the Mounting and Operat-
ing Instructions u EB 9527-3.
To establish communication, the serial interface of the computer must be connected to the se-
rial interface port of the Media 6 device using the SAMSON connecting cable. Following
this, start TROVIS-VIEW 4 and perform the basic settings. The Media 6 device can be config-
ured step-by-step using the start-up wizard.
Write protection switch on the Media 6 device set to OFF.
Refer to the Operating Instructions u EB 6661 on how to use the TROVIS-VIEW 4 software.
6 EB 9527-2 EN