Ip Address And Subnet Mask - Billion BIPAC 5100S User Manual

Billion adsl modem/router with single ethernet port user's manual

Hide thumbs Also See for BIPAC 5100S:

Table of Contents

The following table describes the labels in this screen.

LABEL

Mode

From the Mode drop-down list box, select Routing (default) if your ISP allows

multiple computers to share an Internet account. Otherwise select Bridge.

Encapsulation

Select the encapsulation type your ISP uses from the Encapsulation drop-down

list box. Choices vary depending on what you select in the Mode field.

If you select Bridge in the Mode field, select either PPPoA or RFC 1483.

If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP

or PPPoE.

Multiplex

Select the multiplexing method used by your ISP from the Multiplex drop-down

list box either VC-based or LLC-based.

Virtual Circuit ID

VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual

circuit. Refer to

VPI

Enter the VPI assigned to you. This field may already be configured.

VCI

Enter the VCI assigned to you. This field may already be configured.

Click this button to go to the next wizard screen. The next wizard screen you see

depends on what protocol you chose above. Click on the protocol link to see the

next wizard screen for that protocol.

3.6 IP Address and Subnet Mask

Similar to the way houses on a street share a common street name, so too do computers on a

DESCRIPTION

Table of Contents