Simplicity Broadmoor 2691467 Operator's Manual page 15

5. Clean the battery terminals and cable ends with a wire
brush and battery terminal cleaner.
6. Install the battery with the battery hold-down strap (B).
7. First connect the positive (+) battery cable to the battery.
Then, connect the negative (-) battery cable (A, Figure 9)
to the battery.
8. Apply a layer of petroleum jelly or non-conducting grease
to the cable ends and the battery terminals.
Charge the Battery
WARNING
Keep open flames and sparks away from the battery; the
gasses coming from it are highly explosive. Ventilate the
battery well during charging.
A dead battery or one too weak to start the engine can be the
result of a defect in the charging system or other electrical
component. If there is any doubt about the cause of the
problem, see your dealer. If you need to replace the battery,
follow the steps under Clean the Battery and Cables.
To charge the battery, follow the instructions provided by the
battery charger manufacturer as well as all warnings included
in the safety rules sections of this book. Charge the battery
until fully charged. Do not charge at a rate higher than 10
amps.
Mower Blade Stop Time
WARNING
If the mower blade does not come to a complete stop within
5 seconds, the clutch must be adjusted. Do not operate the
machine until the correct adjustment has been performed by
an Briggs & Stratton Authorized Service Dealer.
The mower blades and mower drive belt must stop within
five seconds after the electric Power Take-Off (PTO) switch
turns OFF. If the mower drive belt does not stop within five
seconds, see a Briggs & Stratton Authorized Service Dealer
for repairs.
Change the Engine Oil
1. Run the engine until warm.
2. Put the tractor on a level surface (Figure, 10).
10
3. Stop the engine and remove starter insert (A, Figure 10).
4. Clean the oil fill and filter areas of any debris.
5. Remove dipstick (B) and lay on clean cloth.
6. Disconnect the oil drain hose (A, Figure 11).
15