Reznor FT Series Instructions Manual

All gas conversion must be done by a qualified service person in accordance with these instructions and in compliance with all codes and require-
ments. In Canada, gas conversion shall be carried out in accordance with the requirements of the Provincial Authorities having jurisdiction and in
accordance with the requirements of the CAN/CGA-B149.1 and .2 installation code.
WARNING: Improper installation, adjustment, alteration, service, or maintenance can cause
property damage, injury, or death. For assistance or additional information, consult a qualified
FOR YOUR SAFETY
What to do if you smell gas:
• Do not try to light any appli-
ance.
• Do not touch any electrical
switch; do not use any phone
in your building.
• Immediately call your gas sup-
plier from a neighbor's phone.
Follow the gas supplier's
instructions.
• If you cannot reach your gas
supplier, call your fire depart-
ment.
FOR YOUR SAFETY
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other
appliance.
DANGER:
The conversion kit is to be
selected and installed by a qualified
service person in accordance with
these instructions and in compliance
with all codes and requirements of
authorities having jurisdiction. Failure
to follow instructions could result in
death, serious injury and/or property
damage. The qualified agency
performing this work assumes
responsibility for this conversion.
installer, service agency, or the gas supplier.
1. DANGER: Failure to comply will result in severe personal injury or death
and/or property damage.
2. WARNING: Failure to comply could result in severe personal injury or death
and/or property damage.
3. CAUTION: Failure to comply could result in minor personal injury and/or
property damage.
Application and Kit Selection
The gas conversion kits in these instructions are for Model FT and Model SFT
heaters equipped with a single-stage valve. See pages 6 and 7 for conversion kit
components.
Be sure that the kit selected applies to the model and size being converted.
DANGER: The gas burner in this gas-fired equipment is designed
and equipped to provide safe and economically controlled
complete combustion. However, if the installation does not permit
the burner to receive the proper supply of combustion air,
complete combustion may not occur. The result is incomplete
combustion which produces carbon monoxide, a poisonous gas
that can cause death.
Safe operation of indirect-fired gas burning equipment requires
a properly operating vent system which vents all flue products
to the outside atmosphere. FAILURE TO PROVIDE PROPER
VENTING WILL RESULT IN A HEALTH HAZARD WHICH
COULD CAUSE SERIOUS PERSONAL INJURY OR DEATH.
On separated combustion Model SFT heaters, install either the
horizontal or vertical combustion air/vent system illustrated in
the heater installation manual, using the concentric adapter
supplied. For installations of either Model FT or Model SFT,
always comply with the combustion air requirements in the
installation codes and instructions. Model FT units installed in
a confined space must be supplied with air for combustion as
required by Code and in the heater installation manual.
Combustion air at the burner should be regulated only by
manufacturer-provided equipment. NEVER RESTRICT OR
OTHERWISE ALTER THE SUPPLY OF COMBUSTION AIR
TO ANY HEATER. MAINTAIN THE VENT SYSTEM IN
PROPERLY OPERATING CONDITION.

Gas Conversion

INSTALLATION FORM RGM 432/433-GC (Version D.1)
Obsoletes Form RGM 432/433-GC (Version D)
APPLIES TO:
HAZARD INTENSITY LEVELS
Kits and
Instructions
Model FT and Model SFT
Mfg No. 148066, Page 1