Ford Taurus Manual page 521

9. For the expansion-type plug, it is important to pull the plug into the machined bore
by using a properly designed tool. Never drive the plug into the bore using a tool
that contacts the flange. Leakage and/or plug blowout will result. the flanged
(trailing) edge must be below the chamfered edge of the bore to effectively seal the
plugged bore.
Use the proper installation tool when installing an expansion-type plug
10. Install all the removed components. Lower the vehicle, as required.
11. Fill the cooling system and check for leaks.
Block Heater
REMOVAL & INSTALLATION
1. Disconnect the negative battery cable. Drain the cooling system.
2. Remove the necessary components to gain access to the engine block heater.
3. As required, raise and support the vehicle safely.
4. Carefully remove the engine block heater from its mounting on the engine block.
5. Installation is the reverse of the removal procedure.
file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm
Use the proper tool when installing a cup-type plug
Стр. 191 из 211
18.11.2005