Ford Taurus Manual page 1182

INSTRUMENTS AND SWITCHES
2. Remove the lower left-hand finish panel.
3. Remove the two screws retaining the headlight switch to the finish panel, then
disengage the electrical connector and remove the switch.
To install:
4. Position the switch, engage the electrical connector, then install the switch using
the two retaining screws.
5. Install the lower left-hand finish panel.
6. Connect the negative battery cable.
1990-95 Vehicles
1. Disconnect the negative battery cable.
2. Pull off the headlight switch knob, then remove the retaining nut.
3. Remove the instrument cluster finish panel as follows:
http://www.chiltondiy.com/content/8687/8687_6_8.html
Sable headlight switch location-1986-89 vehicles
Click to enlarge
1. Disconnect the negative battery cable.
2. Apply the parking brake.
3. Remove the ignition lock cylinder.
4. If equipped with a tilt column, tilt the column to the
most downward position, then remove the tilt lever.
5. Remove the four bolts and opening cover from
under the steering column.
6. Remove the steering column trim shrouds.
Disengage all electrical connections from the
steering column multi-function switch.
7. Remove the two screws retaining the multi-function
switch, then remove the switch.
8. Pull the gear shift lever to the full down position.
9. Remove the four cluster opening finish panel
retaining screws. Remove the finish panel by
pulling it toward the driver to unsnap the snap-in
retainers and disconnect the wiring from the
switches, clock and warning lights.
Стр. 14 из 17
18.11.2005