Ford Taurus Manual page 1126

CRUISE CONTROL
Place the air bag module on the bench with the trim cover facing
upward to prevent personal injury in the event of accidental
deployment of the air bag.
6. Disconnect the speed control switches and horn switches from the contact
assembly.
7. Remove the steering wheel retaining bolt.
8. Using Steering Wheel Puller T67L-3600-A or equivalent suitable puller, remove the
steering wheel.
Using a suitable steering wheel puller, remove the steering wheel
9. If equipped, remove the tilt lever.
10. Remove the lower trim panel and lower steering column shroud.
11. Disconnect the contact assembly wiring harness.
12. Apply two pieces of tape across the contact assembly stator and rotor to prevent
accidental rotation.
13. Remove the three contact assembly retaining screws, then lift the contact
assembly off the steering column shaft.
http://www.chiltondiy.com/content/8687/8687_6_5.html
Click to enlarge
Стр. 17 из 33
18.11.2005