Hyundai GENESIS COUPE BK 2010 Manual page 3369

Specification
※ Voltage value of potentiometer as a function of mode door position.
Mode Door Position
Diagnostic Circuit Diagram
Monitor Scantool Data
■ Actuation Test
1. Connect scantool with diagnostic connector.
2. Warm up the engine to normal engine temperature afte engine starts.
3. Select and monitor "Direction Potention" parameter on scantool.
4. Select and perform Actuation test Driver Mode Door - Face / Foot / Defrost in order.
5. Check that the value of all the parameters are changed when performing the actuation test.
Specification : Face - About below 10%, Foot : About 50%, Defrost : About 90%.
VENT
BI-LEVEL
FLOOR
MIX
DEF
Voltage
0.5±0.2V
1.5±0.2V
2.6±0.3V
3.5±0.2V
4.5±0.2V