Table of Contents
Advertisement
CS
LIFTGATE LIGHT BAR (Continued)
1 - LIFTGATE LIGHT BAR HARNESS GROMMET
2 - LIFTGATE LIGHT BAR
3 - LIFTGATE
4 - OUTER LIFTGATE PANEL
PROP ROD ASSEMBLY
REMOVAL
(1) Open the liftgate and support.
(2) Using a small flat bladed tool, or equivalent,
release the retaining clips while pulling the ball
socket away from the ball stud. (Fig. 7)
NOTE: Lift the clips only enough to release the ball
studs. (Fig. 8)
(3) Remove the support cylinder.
INSTALLATION
(1) Make sure the retaining clips are seated into
the ball socket fully.
(2) Install the support cylinder over the ball studs
with the thin end connected to the liftgate and the
retaining clips snapping into place.
Fig. 6 LIFTGATE LIGHT BAR - REMOVE/INSTALL
5 - LIFTGATE LIGHT BAR ELECTRICAL CONNECTOR
6 - LIFTGATE WIRING HARNESS
7 - INNER LIFTGATE PANEL
Fig. 7 SUPPORT CYLINDER REMOVAL
1 - BALL SOCKET
2 - RETAINING CLIP
3 - FLAT BLADED TOOL
4 - BALL STUD
LIFTGATE 23 - 107
Advertisement
Table of Contents
