User Control Menu - Sony LMD-1950MD Instructions For Use Manual

USER CONTROL menu

The USER CONTROL menu is used for adjusting the
picture.
Items that cannot be adjusted depending on the input
signal are displayed in blue.
U S E R C O N T R O L
xC H R O M A
· P H A S E
· A P E R T U R E
· G A M M A
· A S P E C T
· S C A N
· P I C D E L AY M I N
Submenu
CHROMA
PHASE
APERTURE
GAMMA
ASPECT
20
Adjustment Using the Menus
xx
xx
xxx
x
xxx
xxxxxx
xxx
Setting
Adjusts color intensity. The higher
the setting, the greater the intensity.
The lower the setting, the lower the
intensity.
Adjusts color tones. The higher the
setting, the more greenish the
picture. The lower the setting, the
more purplish the picture.
Adjusts the picture sharpness. The
higher the setting, the sharper the
picture.
Selects the appropriate gamma
mode. You can select from among
5 settings.
• 1 (2.6)
• 2 (2.4)
• 3 (2.2)
• 4 (2.0)
• 5 (DICOM)
When "3" is selected, the setting is
roughly same as the gamma mode
of the CRT.
Sets the aspect ratio of the picture.
When inputting 16:9 (squeezed)
signal from equipment such as a
DVD player, set to 16:9.
• 4:3: When the picture with ratio
4:3 is input.
• 16:9: When the picture with ratio
16:9 (squeezed) is input.
Submenu Setting
SCAN Sets the scan size of the picture.
Select from among "NORMAL",
"UNDER", "OVER", "FULL",
"ZOOM" and "NATIVE (1080I and
720P only)" (see "Scan mode
image" on page 21).
Note
When inputting the 1035/60I
signal, the signal format is
displayed as 1080/60I on the
screen. A slightly squashed picture
is displayed at a little lower
position, because the picture is
displayed in 1035/1080 picture
ratio on a 16:9 screen. Adjust the
position to the center using the
SHIFT V setting (on page 22).
PIC DELAY MIN Selects to set the delay by the
picture processing to the minimum
level when the NTSC, PAL, 480/
60I, 575/50I or 1080I signal is
input.
• 0: Mode for giving precedence
to the picture quality
(recommended mode). This is a
mode suitable for an animation
and a still picture. It takes
longer than "1" or "2" for
processing the picture.
• 1: The processing time is short
and this is a mode suitable for an
animation.
• 2: The processing time is short
and this is a mode suitable for a
still picture.