Advertisement
Die Assembly
13.564-13.571
46754-2
[.5340-.5343]
15.037-15.044
46755-2
[.5920-.5923]
16.612-16.619
46756-2
[.6540-.6543]
17.831-17.838
46757-2
[.7020-.7023]
19.406-19.413
46758-2
[.7640-.7643]
If the crimping chamber DOES conform to the gage inspection, the dies may be considered dimensionally
correct and should be lubricated with a THIN coat of any good SAE 20 motor oil.
If the crimping chamber DOES NOT conform to the gage inspection, refer to Section 7 for information on
obtaining further evaluation and repair.
NOTE: For additional information regarding the use of a plug gage, reference Instruction Sheet 408-7424.
Rev C
Figure 10
Gage Element Diameter
GO
NO-GO
13.815-13.818
[.5439-.5440]
15.288-15.291
[.6019-.6020]
16.863-16.866
[.6639-.6640]
18.082-18.085
[.7119-.7120]
19.657-19.660
[.7739-.7740]
Figure 11
Gage Element Diameter
Die Assembly
GO
20.422-20.429
46759-2
[.8040-.8043]
21.539-21.547
46760-2
[.8480-.8483]
18.288-18.296
59870-1
[.7200-.7203]
12.421-12.428
69653
[.4890-.4893]
408-1602
NO-GO
20.673-20.676
[.8139-.8140]
21.791-21.793
[.8579-.8580]
18.539-18.542
[.7299-.7300]
12.672-12.675
[.4989-.4990]
10 of 11
Advertisement
