Setting Up A Network Port; Setting Up A Port On Windows Xp/2000 - Epson Stylus C84WN Setup And Installation Manual

Setting Up a Network Port

The steps for setting up a network port vary depending on your operating system.
Before you begin, print a status page and note the IP address of your print server.
Make sure the printer driver is installed, as described on page 21.
Then follow the instructions in one of these sections:
If you're using Windows XP or 2000, follow the steps in the next section.
If you're using Windows Me or 98, go to page 30.
If you're using Windows NT, go to page 32.

Setting Up a Port on Windows XP/2000

The process of setting up a network port is similar on Windows XP or 2000.
Although this section shows Windows XP, you'll see similar screens in Windows
2000. For either system, make sure you are logged on to the computer as an
administrator.
1. Do one of the following:
In Windows XP, click
Hardware > Printers and Faxes
In Windows 2000, click
2. Right-click the
Properties
3. On the Ports tab, click
see this window:
4. Select
Standard TCP/IP Port
New Port
TCP/IP Printer Port wizard.
28
Installing and Configuring the Software for Windows
Start > Control Panel > Printers and Other
Start > Settings > Printers
EPSON Stylus C84 Series
.
Add Port
and click
. You see the Add Standard
.
printer icon, then click
. You
.