Installing The C84Wn Software - Epson Stylus C84WN Setup And Installation Manual

Make sure you have selected the correct network name or SSID (Service Set
Identifier).
In Windows XP, check your Wireless Network Connection Properties and
make sure your settings are correct.
If you're using WEP (Wired Equivalent Privacy) encryption, you need to
temporarily disable it on your computer. This allows you to connect to and
configure the print server. Follow the instructions in your wireless adapter's
documentation.
Be sure to write down the WEP key used on your network. After you
configure the print server, you can enable WEP on your computer again.
Note:
If your access point only allows WEP-enabled clients to connect to it, you may
have to set your computer's wireless mode to 802.11b Ad Hoc before you
configure the print server.
If you're going to use the printer in ad hoc mode, note the IP address of your
computer. (For instructions on viewing a computer's IP address, see page 56.)
If you're using infrastructure mode, make sure there is a link with good signal
strength (at least 50 percent) between the computer and the access point. See
your wireless adapter's documentation for details.

Installing the C84WN Software

Your printer software CD-ROM includes the following software:
EPSON Stylus C84WN printer driver
You must install the printer driver on every computer that uses the EPSON
Stylus C84WN printer. This software controls print settings and provides
several utilities for printer maintenance. For instructions on using your printer
driver, see the Printer Basics book.
EpsonNet Wireless Print Server Utilities
These utilities include WP-Admin, which lets you configure the print server
for most network protocols, and XAdmin32, which lets you configure the
print server for a Novell
configuration for other protocols. You only need to install the utilities on one
computer on your wireless network.
20
Installing and Configuring the Software for Windows
®
NetWare network or perform more advanced