Figure 1-3 Mounting Bracket Locks - Fujitsu SPARC Enterprise T1000 Installation Manual

The slide rail assembly has the following features:
The front and rear sections form the slide rail. The front and rear sections expand
■
to fit rack depths from 24 in. (610 mm) to 29.0 in. (740 mm).
Extension brackets are included in the mounting rail kit. The extension brackets
■
add 2.9 in. (73 mm) to the length of each slide rail.
The mounting bracket slides 13 in. (330 mm) out of the slide rail, then locks in
■
place. If you unlock the mounting bracket, it slides an additional 4 in. (100 mm)
before separating from the slide rail. The mounting brackets mount directly to the
sides of the server chassis.
There are two locks on each server mounting bracket (
■
enables the mounting bracket to slide forward. The mounting bracket release
allows you to remove the mounting bracket from the slide rail. You also use the
release when pushing the mounting bracket into the slide rail.
FIGURE 1-3
6 SPARC Enterprise T1000 Server Installation Guide • April 2007
Mounting Bracket Locks
). The lock
FIGURE 1-3
Mounting bracket release
Mounting bracket lock (2 buttons)