Toyota Tundra 2005 Service - Repair - Maintenance page 978

4 Check sensor installation (Vehicle speed sensor).
Clearance
OK
OK
5 Check for open and short in harness and connector between combination meter
and ECM.
Wire Harness Side:
Front View
C11
Combination Meter Connector
OK
Check combination meter circuit (See page
BE−86).
DIAGNOSTICS
CHECK:
Check the vehicle speed sensor installation.
OK:
NG
NG
BR3795
PREPARATION:
(a)
E4 (b)
CHECK:
Check for resistance between the wire harness side connec-
tors.
OK:
SPD(+)
B17411
A23540
NG
− ENGINE (2UZ−FE)
The vehicle speed sensor is installed properly.
Tighten sensor installation bolt.
Disconnect the C11 combination meter connector.
Disconnect the E4 ECM connector.
Standard (Check for open):
Symbols (Terminal No.)
SPD (E4−8) − C11−23
Standard (Check for short):
Symbols (Terminal No.)
SPD (E4−8) or C11−23 − Body ground
Repair or replace harness or connector.
DI−705
Specified condition
Below 1 Ω
Specified condition
10 kΩ or higher