Table of Contents
Advertisement
3.4 Technical progress
SWR reserves the right to adapt technical data to the technical progress without particular
advance notice. If you have any questions, SWR engineering will be pleased to inform you on
possible changes and extensions of the operating instructions.
4. Mounting and installation
4.1 Delivery scope
4.2 Necessary auxiliaries
4.3 Mounting of the sensors
M-Sens 2 is designed for continuous moisture measurement. Most important condition for
correct measurement is the right choice of the mounting place of the sensor. That is, when
using chutes or conveyor belts, it is very important to have a almost even material height in
front of the sensor window.
The flange is welded without sensor and dummy plate in the opening at determined mounting
place. Sensor and dummy plate are mounting by means of plumbing lubricant. For applica-
tions without over-pressure it is possible to renounce the 2 sealing rings.
Attention!
The Flange mustn't be welded together with the sensor or dummy plate (incl. the seal-
ing
6
Evaluation unit in the field housing
Sensor
Mounting
C-box
Screw driver 2,5 mm
Allen key 5 mm
rings).
Advertisement
Table of Contents
