Christie Roadie HD+35K Instruction Sheet page 4

F V
AN IBRATION
Replace the existing gel isolators with rubber isolators.
1. Remove back top cover and exhaust lid assembly. See section 5.3.2 Back Top Cover/Exhaust Lid
Assembly of the service manual (P/N 020-100341-XX) for more details.
2. Remove (3) nuts securing the fan bracket to the vibration mounts.
3. Remove fan bracket assembly carefully.
4. Remove the existing (3) gel isolators.
5. Install (3) new black rubber isolators.
6. Reinstall the fan bracket assembly.
7. Secure the fan bracket assembly to the new rubber isolators with the (3) 10-32 screws and the (3)
flat washers provided.
8. Torque the (3) screws to 12in-lbs (1.36Nm).
9. Reinstall the back top cover and the exhaust lid assembly.
P O
ROJECTOR
Once oriented in portrait mode, lamp alignment must be performed for optimum brightness.
4 of 4
I
SOLATORS
RIENTATION
For portrait mode, the projector MUST be oriented with lens closest to
the top side up. Failure to do so will cause damage to the projector. Max
tilt ±15 degrees.
Roadie HD+35K Portrait Upgrade Kit Instruction Sheet
020-100778-03 Rev. 1 (03-2012)