Christie Roadie HD+35K Instruction Sheet page 2

KITS REQUIRED
Kit Portrait Mode Roadie (P/N 000-102632-XX) includes:
• (1) Lamp Anode Stand Assembly (P/N 000-102637-XX)
• (3) Rubber Isolator (P/N 012-100753-XX)
• (3) 10-32 Screw (P/N 012-100425-XX)
• (3) Flat washers (P/N 012-100500-XX)
• (2) Wire rope lanyard 6-inch LG (P/N 012-100997-XX)
TOOLS REQUIRED
• #2 Phillips® screwdriver
• 3/8-inch wrench
• 3/16-inch Hex driver
INSTRUCTIONS
F T C
RONT OP OVER
Secure the front top cover to the projector to prevent it from falling off while using in portrait mode.
Cover Should be locked when projector is in use.
1. Unlock the lid.
2. Lift lid.
3. Loop cable through slot.
4. Feed terminal end through the loop.
5. Remove screw and install terminal.
6. Reinstall screw.
7. Repeat steps 2-5 for other side.
8. Close and lock lid.
2 of 4 Roadie HD+35K Portrait Upgrade Kit Instruction Sheet
020-100778-03 Rev. 1 (03-2012)