Cb70 Status Leds; Battery Charging Tips - Danfoss T70 1 User Manual

User Manual
T70 1 Transmitter
Charger and battery

CB70 status LEDs

Remote control battery charging tips
© Danfoss | March 2019
2. Place the batteries in the compartments of the battery charger.
3. Optional: If charging multiple batteries, wait at least 5 seconds before placing the second battery in
the other compartment.
Possible damage to battery!
Be sure to charge batteries in environments with temperatures over 0° C.
Each battery compartment has an LED that indicates the status of the batteries' charge.
Green LED; pulsing
Green LED; continuous
Green LED; off
The battery charger must be placed and used out of the danger area.
The battery lifespan is estimated to be 500 recharging cycles and is largely dependent on the conditions
of use.
To maximize the lifespan of the batteries and battery charger, follow these tips:
•
Do not recharge the battery until needed, as shown with slow, red LED pulse on the transmitter
•
Always charge the batteries at temperatures between 0° and 45° C
•
Do not leave the battery charger or batteries in direct sunlight
•
Charge batteries at least once every six months
•
Avoid short circuits between the battery contacts; do not transport charged batteries in toolboxes or
next to other metal objects
•
Always keep contacts clean
Battery is excessively depleted
Normal charging operation mode
Battery charging process is complete
BC300870271580en-000101 | 11