Table of Contents
Advertisement
BEATER
Periodically inspect the beater for wear or damage. Replace damaged or worn beater blades. Always
use H&S special grade 5 bolts, washers, and nuts when replacing blades. Torque bolts to 60 ft. lbs.
Consult with your local H&S dealer for additional ordering information.
WHEEL BEARING LUBRICATION, CLEAN & RE-PACK INSTRUCTIONS
Wheel hubs are equippped with a grease zerk for regular maintenance. Annually disassemble and
clean parts in solvent. Reassemble bearings per instructions in the Service Chapter and tighten the
castellated nut on the spindle to the point where there is no end-play and a slight drag on the bearings.
Replace the cotter key with a new one of the correct size, bend cotter pin over and re-install cap.
TIRES & WHEELS
Check the tire pressure after every 50 hours of operation. Tires should be inflated to the appropriate
pressure listed in the table.
Tire
295/75R22.5
Wheel lug torque should be checked after every 50 hours of operation and tightened to the appropriate
Wheel bolts must be tightened between 85-95 ft./lbs. of torque.
torque.
SERVICE
Pressure
75-80 PSI
-19-
Hide quick links:
Advertisement
Table of Contents
