Example: Setting Up The Hardware - Allen-Bradley RightSight 42EF Series User Manual

Setting up the 42EF for IO-Link Mode
Example: Setting Up 
the Hardware
18
In this example, we are showing an Allen-Bradley POINT I/O chassis with a
1734-AENTR adapter and a 1734-4IOL IO-Link master module in the first
slot. The 1734-AENTR is communicating with a CompactLogix™ controller via
EtherNet/IP.
Patchcords (1 pc.) 889D-F4ACDM-2)
42EF
When adding a 42EF to the 1734-4IOL master module, complete the following
steps:
1. Provide power to the 1734-AENTR adapter.
2. Set the node address on 1734-AENTR adapter.
3. Connect the 1734-AENTR to the Allen-Bradley controller with the
recommended RJ45 Ethernet cable.
4. Wire the sensor cable to the desired location on the IO-Link master (in this
example, we are showing the sensor that is wired to the channel 0).
5. Connect the 42EF to the other end of the sensor cable.
Rockwell Automation Publication 42EF-UM001A-EN-P - September 2015