Mrw-10 Amp Panel & Controls - Monitor Audio Monitor 50 Owner's Manual

MRW-10 Amp Panel & Controls
INPUT
2
LFE
R
1
L
1. RCA Stereo Inputs (Left & Right)
This is the method of signal input when using a stereo amplifier system, connection can be provided
by a pair of high-quality signal cables from the pre-out section of an amplifier. The crossover
frequency will need to be set if using this method of connection. We recommend setting the
crossover dial to approximately 80Hz as a starting point. This may vary depending on room and
tastes.
NOTE:- cable lengths should not exceed 10 metres to avoid interference from other electrical
appliances.
2. LFE Input (RCA Type)
This input is to be used when connecting the subwoofer to an AV amplifier/ receiver. When using
the LFE input, the crossover frequency dial is not used. This is due to the crossover function being
controlled by the AV amplifier/ processor to which it is connected.
3. 12 Volt Trigger Input ~ Centre Pin = +12Vdc
For external power control from AV amplifier/ receiver to the MRW-10. A 12 volt signal is supplied
by the AV amp/receiver and tells the MRW-10 to turn on from standby mode. This allows a more
accurately controlled auto on/off function, and is far more energy efficient. When using the 12v
trigger, the Mode Switch (8) must be in the Auto position for it to function correctly. Once the AV
receiver has been turned off the MRW-10 will remain on for around 15 minutes before going into
standby. The cable is supplied seperately.
4. Crossover Frequency Control
The crossover frequency control only operates when using the RCA stereo input (1) and is used
to set the upper frequency limit (low pass) of the subwoofer. The crossover control should be
set in accordance with the size or bass output of the main/satellite speakers. When using the
Monitor Series speakers, set this to between 50 - 100Hz (depending on additional speakers).
Experimentation is advisable.
Type of Main Speaker
Small stand-mount/ bookshelf speaker
Floor Standing Speaker
6
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK.
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED PERSONNEL.
ATTENTION: AFIN DE RÉDUIRE TOUT RISQUE DE CHOC
ÉLECTRIQUE, NE PAS RETIRER LE COUVERCLE
(OU CAPOT ARRIERE), NE CONTIENT PAS DE PIECES
REPARABLES PAR L'UTILISATEUR CONFIER TOUT
ENTRETIEN À UN PERSONNEL QUALIFIÉ.
3 4
TRIGGER
FREQUENCY
.
.
.
12V
.
50 Hz 120 Hz MIN
220 - 240V~
110 - 120V~
POWER
Monitor Series Product
Monitor Series
5 6
BASS
VOLUME
IMPACT
.
.
MUSIC
. . .
MOVIE
.
. .
MAX
ON
OFF
Monitor 50/ 100
Monitor 200/ 300
7 8
PHASE MODE
AUTO
ON
DESIGNED IN THE UK, MADE IN CHINA
Notes:
1. ICONS/TEXT TO BE SILKSCREENED
IN WHITE - RAL 9003
2. IMAGE FOR REFERENCE PURPOSES ONLY.
3. DO NOT SILK SCREEN TEXT
FOR REGERENCE PURPOSES ONLY.
Crossover Control Setting
60-100 Hz
50 - 80 Hz
9
10
AC110-120V ~ 50-60Hz
AC220-240V ~ 50-60Hz
200 W
FUSE: 110-120VAC T4AL/250VAC
FUSE: 220-240VAC T4AL/250VAC
10a
11
IN RED -