Table of Contents
Advertisement
Air conditioner
on and off too much, or does not cool room
Check if . . .
MODE Control is set to
POWER SAVER.
Then . . .
Use POWER SAVER only when you are away from home or asleep, since the fan
does not circulate the room air continuously.
Use LOW COOL, MED COOL or HIGH
COOL for your best comfort.
The air conditioner
is not
Check the cooling capabilities
of your room air conditioner.
Room air conditioners
are
properly sized for your room.
not designed to cool multiple rooms.
The filter is dirty or
Clean the filter. See page 14.
obstructed by debris.
The inside evaporator and
Clean the inside evaporator and outside condenser coils. See page 17.
outside condenser coils are
dirty or obstructed by debris.
There is excessive heat or
Use a fan to exhaust heat or moisture from the room. Try not to use heat-producing
moisture (open container
appliances during the hottest part of the day.
cooking, showers, etc.)
in the room.
The louvers are blocked.
Install the air conditioner
in a location where the louvers are free from curtains, blinds,
furniture, etc.
The outside temperature is
Do not try to operate your air conditioner
when the outside temperature
is below
below 65°F (18°C).
65°F (18%).
The temperature
of the room
Allow extra time for the air conditioner
to cool off a very hot room.
you are trying to cool
is extremely hot.
Windows or doors to the
Close all windows and doors.
outside are open.
The VENT Control is
Set the VENT Control to CLOSED for maximum cooling.
set to FRESH AIR/
EXHAUST.
The TEMP Control is not at a
Adjust the TEMP Control to a cooler setting by turning the knob clockwise. Turn MODE
cool enough setting.
Control to HIGH COOL.
The air conditioner
is
Install your air conditioner
in a more shaded window.
installed on the sunny
side of your house.
Water drips from cabinet
into your house
Check if . . .
The air conditioner
is not
properly leveled. The air
conditioner
should slope
slightly downward toward
the outside.
Then ..,
Level the air conditioner to provide a downward slope toward the outside (l/2 bubble
on a carpenter's level) to ensure proper drainage. See the Installation
Instructions.
Reposition or shim the cabinet as necessary.
NOTE: Do NOT drill a hole in the bottom of the metal base and condensate
pan.
21
Hide quick links:
Advertisement
Table of Contents
