Northern IP4DIR100 Installation & Quick Setup Manual page 26

IP4DIR100 Series IP Dome Camera · Quick Start Guide
No.
1
2
3
4
5
6
7
Steps:
1. Feed the plugless network cable ⑦ through the lock nut ⑥,
waterproof rubber gasket ⑤ (rubber gasket inset ridge must
face waterproof endcap), and the waterproof endcap ④ in
order.
2. Crimp an RJ-45 network plug ③onto the end of the cable,
taking care to insert the twisted pairs of wires in correct order.
3. Place the O-type gasket ② onto the end of the camera's
network interface socket ①.
4. Insert the network plug ③ into the camera's network interface
socket ①.
Table 2-1 Components
Components
Camera's Network Interface Socket
O-Type Gasket
Network Plug
Waterproof Endcap
Waterproof Rubber Gasket
Lock Nut
Network Cable from Router/Switch
25