Electrical / Refrigeration; Merchandiser Electrical Data; Field Wiring; Electrical Connections - Hussmann SHM Series Installation & Operation Manual

Medium temperature self contained specialty horizontal merchandiser
Table of Contents

Advertisement

P/N 0515258_N

MERCHANDISER ELECTRICAL DATA

Refer to Appendix A of this manual or the
merchandiser's serial plate for electrical
information.

FIELD WIRING

Field wiring must be sized for component
amperes stamped on the serial plate. Actual
ampere draw may be less than specified.
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES

ELECTRICAL CONNECTIONS

All wiring must be in compliance with NEC
and local codes. All electrical connections (for
remote models) are to be made in the electrical
Handy Box located behind the removable base
panel at the left end of the merchandiser when
facing the discharge air louver.

ELECTRICAL OUTLET

Before the merchandiser is connected to any
wall circuit, use a voltmeter to check that the
outlet is at 100% of the rated voltage. The wall
circuit must be dedicated for the merchandiser.
Failure to do so voids the warranty. Do not
use an extension cord. Never plug in more
than one merchandiser per electrical circuit.
• Always use a dedicated circuit with the
amperage stated on the unit.
• Plug into an outlet designed for the plug.
• Do not overload the circuit
• Do not use long or thin extension cords.
Never use adapters.
• If in doubt, call an electrician.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.

ELECTRICAL / REFRIGERATION

Self-contained models have factory-installed
power cords attached at the electrical box.
NEMA 5-15R Receptacle
Merchandiser must be grounded.
Do not remove the power supply cord ground.
REFRIGERATION
(Self Contained Models)
Each self contained model is equipped with
its own condensing unit and control panel
located beneath the display area. The
merchandiser refrigeration piping is leak
tested. The unit is charged with refrigerant
and shipped from the factory with all service
valves open.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electri-
cal shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
Risk of Electric Shock. If cord or plug
becomes damaged, replace only with
a cord and plug of the same type.
2-1
SHM Merchandisers

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Shm-3Shm-4

Table of Contents