Cleaning The Downdraft - Caple DD903BK Instruction Manual

CLEANING THE
DOWNDRAFT
Careful maintenance ensures proper operation and good performances over time.
The hood must be disconnected from the electrical network, both by unplugging the appliance
from the socket and activating the magnetic circuit breaker (safety cut-out), before removing the
metal grease filters. After cleaning operations, replace the metal grease filters as outlined in the
installation instructions.
MAINTENANCE
Cleaning external
surfaces and
accessories
Grease filters
Activated charcoal
filter
9
CAUTION
HOW TO PROCEED?
Do not use metallic scrubbers,
abrasive products, or hard brushes.
After 30 hours of operation, the
downdraft will signal the grease filter
saturation. Saturation is indicated
by flashing RED color LED speed
indicator, when the cooker hood is
off. To reset, hold down the timer
button for at least 3 seconds,
while the hood is OFF.
In the recirculation mode, the
active charcoal filter must be
replaced periodically.
To remove the charcoal filter first of
all it is necessary to remove the
grease filter and then pull the
plastic key of the panel itself, in
order to disengage it from its seating.
Follow these steps in reverse order
to insert the active charcoal filter.
Replace the used charcoal filter on
an average of every six months.
ACCESSORY PRODUCTS TO
USE
To clean the external surfaces of the
downdraft and the light housing
screen use only
available household
diluted in water. Then rinse with
clean water and dry with a soft cloth.
The grease filters can be washed by
hand or in the dishwasher. These
filters need to be cleaned on a
regular basis, because otherwise
they may represent a fire risk.
Refit the grease filters and front
panel, making sure that they are
properly fitted at the sides so that
it does not cause the downdraft to
stop operating.
commercially
detergents